在近年來人們開始提倡綠能發展，除了增加再生能源的利用之外，能源回收
也是一直是被大家所廣泛討論的課題。而在現今的社會，與過去不同的是，可攜
式電子產品近年來發展快速，現在幾乎人手至少一台可攜式電子產品，無論是智
慧型手機、平板電腦或是數位相機等，若把所有人在可攜式電子產品上的耗能加
總，其值是非常驚人的。為了解決此問題，本篇論文提出一種利用可攜式發電機
對手機電池充電的想法，目的是要利用可攜式發電機產生能量，提供電子產品做
充電使用，而在可攜式發電機與電子產品之間就需要一個電壓調整器來穩壓。本
研究即提出一個無輸出電容式低壓降電壓調整器，其不僅擁有較小的晶片面積以
及消耗功率外，而且在不需要輸出電容的情形下，能有穩定的輸出電壓且容易與
前後端電路做整合，增進了使用的便利性。
此晶片所採用的是TSMC 0.35μm 2P4M CMOS 製程來實現，在輸入電壓6V
的情形下，輸出電壓為5V，滿載電流約為300mA，晶片面積大小為1.013 
1.013mm2，可在無輸出電容的情形下有穩定輸出電壓。

中文摘要 ……………………………………………………………………………………………………………i
英文摘要(Abstract) …………………………………………………………………………… ii
目錄 ………………………………………………………………………………………………………………iii
表目錄 ………………………………………………………………………………………………………………vi
圖目錄 ……………………………………………………………………………………………………………vii
第一章 緒論 ……………………………………………………………………………………………………1
第二章 低壓降電壓調整器與帶差參考電路原理之介紹 ………………………6
第三章 發電機後端電壓調整器電路之實現 …………………………………………30
第四章 晶片模擬結果與佈局考量 ……………………………………………………………51
第五章 晶片量測結果 …………………………………………………………………………………72
第六章 結論與後續研究建議 ……………………………………………………………………83
參考文獻 …………………………………………………………………………………………………………85

[1] J. J. Chen, F. C. Yang, C. M. Kung, B. P. Lai, and Y. S. Hwang, “A capacitor-free fast-transient-response LDO with dual-loop controlled paths,” in Proc. Asian Solid-State Circuits Conference, Nov. 2007, pp. 364-367.
[2] H. C. Yang, M. H. Huang, and K. H. Chen, “High-PSR-bandwidth capacitor-free LDO regulator with 50μA minimized load current requirement for achieving high efficiency at light loads,” WSEAS Trans. Circuits Syst., vol. 7, no. 5, pp.428–437, May 2008.
[3] E. N. Y. Ho and P. K. T. Mok, “A capacitor-less CMOS active feedback low-dropout regulator with slew-rate enhancement for portable on-chip application,” IEEE Transactions on Circuits and Systems II: Express Briefs, vol.57, no. 2, pp. 80-84, Feb. 2010.
[4] J. H. Wang, C. H. Tsai, and S. W. Lai, “A low-dropout regulator with tail current control for DPWM clock correction,” IEEE Transactions on Circuits and Systems II: Express Briefs, vol. 59, no. 1, pp. 45-49, Jan. 2012.
[5] M. S. Lin, “Design and implementation of low-power CMOS voltage regulator,”
master’s thesis, National Taipei University of Technology, Taipei, 2008.
[6] P.R. Gary and R.G. Meyer, Analysis and Design of Analog Integrated Circuits.New York: John Wiley & Sons, Inc., 1993.
[7] Behzad Razavi, Design of Analog CMOS Integrated Circuits. Singapore: McGraw-Hill, 2001.
[8] C. W. Chang, “Design of a self-modulation LDO for power saving,” master’s thesis, National Tsing Hua University, Hsinchu, 2009.
[9] W. L. Chen, “Area-efficient capacitor-free low dropout regulator with current mode feedback compensation,” master’s thesis, National Tsing Hua University, Hsinchu, 2009.
[10] R. G. H. Eschauzier, L. P. T. Kerklaan, and J. H. Huijsing, “A 100-MHz 100-dB operational amplifier with multipath nested miller compensation structure,” IEEE
J. Solid-State Circuits, vol. 27, no. 12, pp. 1709–1717, Dec. 1992.
[11] K. N. Leung and P. K. T. Mok, “Analysis of multistage amplifier—frequency compensation,” IEEE Trans. on Circuits and Syst. I, vol. 48, no. 9, pp. 1041–1056, Sep. 2001.
[12] X. Peng and W. Sansen, “Transconductance with capacitances feedback compensation for multistage amplifiers,” IEEE J. Solid-State Circuits, vol. 40, no. 7, pp. 1515-1520, July 2005.
[13] S. F. Ashrafi, S. M. Atarodi, and M. Chahardori, “A new low voltage, high PSRR, CMOS bandgap voltage reference,” in Proc. 2008 IEEE International SOC Conference, Sep. 2008, pp. 345-348.
[14] X. Kang and Z. Tang, “A novel high PSRR bandgap over a wide frequency range,” in Proc. IEEE International Conference on Solid-State and Integrated Circuit Technology (ICSICT), Nov. 2010, pp. 418-420.
[15] C. C. Cheng, “A buck Li-ion battery charger suitable for portable generators and adapters,” master’s thesis, National Tsing Hua University, Hsinchu, 2012.